09-22-2020, 12:43 AM
Hi LiveCloud team,
I may be missing a way to deal with this, but so far I can't see a way around this:
Long table names are truncated (which is fine), but there is no way to see long table names in full within the LCM interface after creation. In a previous version, hovering over the table would show a tooltip with the table name concatenated with the tableID, but currently this shows me the tableID only.
The width of the Tables column is fixed. So other than redesigning everything (in this particular case, the table names match array names, which in turn are taken from data exported from a medical system), it relies on me semi-guessing the table name after it's been created.
Solutions could be to make the Table column resizable or have the table name show up in the tooltip again - but actually i am hoping the table name ± tableID could be put into the 'Data' header that sits above the key names as it serves no real purpose (and perhaps make it selectable so that either the name or ID can be copied for scripting etc).
I'm hoping this can be considered as a feature request.
A screenshot to illustrate:
![[Image: file]](http://www.mediafire.com/file/d0gbbp3w3ch6p3p/feature_request.jpg/file)
I may be missing a way to deal with this, but so far I can't see a way around this:
Long table names are truncated (which is fine), but there is no way to see long table names in full within the LCM interface after creation. In a previous version, hovering over the table would show a tooltip with the table name concatenated with the tableID, but currently this shows me the tableID only.
The width of the Tables column is fixed. So other than redesigning everything (in this particular case, the table names match array names, which in turn are taken from data exported from a medical system), it relies on me semi-guessing the table name after it's been created.
Solutions could be to make the Table column resizable or have the table name show up in the tooltip again - but actually i am hoping the table name ± tableID could be put into the 'Data' header that sits above the key names as it serves no real purpose (and perhaps make it selectable so that either the name or ID can be copied for scripting etc).
I'm hoping this can be considered as a feature request.
A screenshot to illustrate:
Many thanks for considering this...
Stam